Artikel-Nr.: A1615
- Beschreibung
3x JST-PH Parallel-Ladekabel
Für GLA und Atomic AMZ/BZ Lipo Akkus oder jeden anderen 2S Lipo mit JST-PH Anschluss.
Mit diesem praktischen Ladekabel können Sie 4-mm-Bananenstecker an Ladegeräte und das Balance Board des Ladegeräts anschließen.
Auf der Akkuseite haben wir 3x JST-PH-Anschlüsse vorgesehen, damit Sie bis zu 3 Packs gleichzeitig laden/entladen können.
Sie müssen natürlich nicht alle 3 verwenden, es ist völlig in Ordnung, 1 Packung damit aufzuladen, aber wenn Sie bis zu 3 Packungen zusammen laden / entladen möchten, kann dieses Kabel dies tun.
Für diejenigen, die mit dem parallelen Laden noch nicht vertraut sind, können Sie Informationen dazu googeln / auf YouTube verwenden, aber zusammengefasst:
Sie können nur 2S Lipo an dieses Kabel anschließen
300mAh, 330mAh, 360mAh zusammen zu mischen ist in Ordnung
Die Packs sollten in der Spannung einigermaßen ähnlich sein, zum Beispiel 2 Packs 90% voll, 1 Pack leer, ist KEINE so gute Idee, da dies dazu führt, dass viel Strom (Ampere) von den vollen Packs zum leeren Pack fließt.
Laden des leeren Packs mit sehr hohem Strom (AMps), dies kann sogar das Kabel schmelzen, wenn die Packs groß/hoch C genug sind.
Alles leer ist in Ordnung, ~30%, ~40%, ~50%
Mischen ist in Ordnung.
Ladekapazität idealerweise auf Gesamt-mAh der Packs eingestellt
Der Ladestrom kann entsprechend der Gesamtkapazität der Packs skaliert werden
3x JST-PH Parallel charging cable
For GLA and Atomic AMZ/BZ Lipo batteries or any other 2S Lipo with a JST-PH connector.
This handy charge cable allows you to connect 4mm banana plugs to chargers, and the charger's balance board.
On the battery side, we have provided 3x JST-PH connectors so that you can charge/discharge up to 3 packs at a time.
You do not have to use all 3 of course, using it to charge 1 pack is perfectly fine, but if you would like charge/discharge up to 3 packs together, this cable can do it.
For those new to parallel charging, you can google/you tube information on it, but in summary:
- You can only connect 2S Lipo to this cable
- Mixing 300mAh, 330mAh, 360mAh together is ok
- The packs should be reasonably similar in voltage, for example, 2 packs 90% full, 1 pack empty, is NOT such a good idea, as it will cause a lot of current(Amps) going from the full packs to the empty pack, charging the empty pack at very high current(AMps), this might even melt the cable if the Packs are large/high C enough.
- All empty is fine, ~30%, ~40%, ~50% mix together is fine.
- Ideally charger capacity set to total mAh of the packs
- Charger current can scale up according to total capacity of the packs
Durchschnittliche Kundenbewertung:
Anzahl der Kundenbewertungen: 0